DESIGNER EPIC™ Poducha w ptaki
Wysłany przez HUSQVARNA VIKING®
POTRZEBUJESZ
-
HUSQVARNA VIKING® DESIGNER EPIC™ Maszynd do szycia i hafciarka
-
Materiał w Twoim ulubionym kolorze wymiary 45x45cm.
-
Część materiału do naszycia aplikacji -"ptak"
-
Sznurek do wszycia
-
Pasek materiału do wszycia ( przycięty)
-
Zamek niewidoczny 50cm
-
Duża stopka do wszywaniua lamówki (opcjonalne akcesoria)
-
Stopka do zamków krytych opcjonalne akcesoria)
-
Stopka Sensorowa Q-Foot
-
Nici do haftu
-
Nici do szycia
-
Nici do szpulki dolnej
-
INSPIRA® stabilizator
PREPARATIONS
Cut Out All Pieces
Cut out all pieces for the bag according to the measurements in the illustration below. All seam allowances are included (3/4” / 1cm).
Embroider the Front Piece
1. Hoop stabilizer and the front piece fabric (A in the cutting scheme) in a hoop large enough for your selected embroidery design. The bird design is created as an appliqué. Use the fabric marked C in the cutting scheme as appliqué fabric.
2. Embroider the design, remove the fabric from the hoop and remove excess stabilizer.
3. Invisible Zipper – First Side
-
Open the zipper. Place the right edge of the zipper tape on one of the back fabric pieces (B in the cutting scheme), right sides together. Snap on the Clear Invisible Zipper Foot.
-
Sew the first part of the zipper by placing the presser foot with the left groove over the zipper coils. Backstitch and sew along the zipper.
4. Invisible Zipper – Second Side
-
Sew the second part of the zipper to the other back piece (B) by placing the left edge of the zipper tape, right sides together with the left side of the fabric.
-
Place the presser foot with the right groove over the zipper coils. Backstitch and sew along the zipper.
-
Close the zipper and the back piece of the pillow is done.
PIPING
Use piping to give your cushion a professional tailor made finish. Use purchased piping or make your own, giving it the perfect match with your cushion fabric. (See the Accessory User’s Guide at www.husqvarnaviking.com to find instructions on how to make your own piping).
5. Place the front piece of the cushion (A in the cutting scheme) right side up. Place the piping (D in the cutting scheme) along the fabric edge. Overlap the piping to finish off at the end. Stitch in place using a straight stitch with the needle position adjusted to -2.0. Clip the seam allowance of the cord in the corners, to get smooth corners.
6. Open the zipper (approx. 4”/10cm) and place the back piece right side down on top of the front piece. Put fabric and piping layers under the presser foot with the cord to the left of the foot Select straight stitch left needle position.
Sew the cushion together, still using the Mega Piping Foot.
Turn right sides out and enjoy!